NEC Electra Elite IPK General Description Manual page 91

Electra Elite IPK
___________________________________________________________________________________
P-3
P-4
P-5
P-6
P-7
P-8
P-9
___________________________________________________________________________________
General Description Manual
P O W E R F A I L U R E T R A N S F E R
Power Failure Transfer ensures that a customer has access to the Central
Office network during a power outage. The CO/PBX tip and ring are
automatically transferred to the tip and ring of a preselected Single Line
Telephone. The Single Line Telephone can function in the system during
normal operation or be used during a power failure. Each B64-U( ) KSU
provides three circuits for this feature. When power returns, any
conversation in progress is disconnected.
P R E S E T D I A L I N G
Preset Dialing enables a Multiline Terminal user to originate an outgoing call
by predialing digits on the keypad. After dialing the number, the user can go
off-hook, press the Speaker key, or press a line key to make the call.
P R I M E L I N E A S S I G N M E N T
Prime Line Assignment allows a station user to go off-hook and originate an
outside call from the trunk assigned as the Prime Line without pressing the
line key. This feature allows assignment of a trunk, Trunk group, or Route
Advance Block.
P R I V A C Y O N A L L C A L L S
The system provides complete Privacy on All Calls. A station user cannot
enter another conversation unless allowed using Barge-In, Add-On
Conference, or Privacy Release.
P R I V A C Y R E L E A S E
Privacy Release allows the multiline terminal user to release the privacy on
an outside line by pressing a privacy release key programmed on the station.
Another user can then press the same CO/PBX or CAP key to join the
conversation in progress.
P R I V A T E L I N E S
Two outside lines can be programmed as private lines. Only a Multiline
Terminal that is programmed for the Private Lines feature can have access to
these private lines. The Private Line LED status is not displayed on any
other Multiline Terminal.
P R O G R A M M I N G F R O M M U L T I L I N E T E R M I N A L
System Programming can be performed from designated Display Multiline
Terminals in the first two ESI(8)-U( ) ETU ports. Some programming changes
become effective immediately. Other programming changes become
effective after applicable busy telephones and circuits become idle.
Document Revision 4
2 - 37