Toshiba RAV-104SBH-PE Service Manual page 79

6.1.2 Timer Operation
Continuous operation and timer operations are available. The setting of timer operation can be done as
follows:
G
Each time you press the button the display will change in the following sequence:
OFF-ON-CONT.
G
During timer operation, the remaining time is displayed. This is updated every minute.
G
The timer operation range is from 10 minutes to 60 hours in 10 minute steps.
6.1.2.1 Timer Setup
1. TIMER Button
This button selects the timer mode OFF, ON or CONTINUOUS.
Set the timer in the OFF or ON mode.
2. TIMER ADJUST (
The ON or OFF times can be set by these buttons.
G
When the TIMER ADJUST button is pressed once, the time changes by 10 minutes. If the
button is held, the time changes in 1 hour steps.
G
If the operation LED is illuminated, the timer operation will start on completion of the setting.
G
If the operation LED is not illuminated, the timer operation will start on the operation of the
ON/OFF button.
G
The remaining time can be seen throughout the timer operation.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
6. THE REMOTE CONTROLLERS
) Buttons
1
79
www.heronhill.co.uk
2
Fax: 01823 665807