Audio Interface/Control Surface - Zoom R24 Operation Manual

USB

Audio interface/control surface

Connect the R24 by USB to a computer to use it as an audio interface to input and output
sound and as a controller for DAW software.
Connecting the unit as an audio
interface/control surface
❶ Audio interface
The R24 can be used as an interface between a
computer and instruments and other audio equip-
ment, allowing audio signals to be recorded directly
into DAW software, for example.
You can connect instruments and microphones that
require Hi-Z or phantom power when used as an
audio interface.
❷ Control surface
Use the faders and keys on the R24 to control trans-
port and mixer operations in your DAW software.
❶
Install DAW software
Install driver
ZOOM R16/R24 audio driver
Connect R24 to computer
AUDIO INTERFACE
DAW software settings
Device settings
ZOOM R16/R24 audio driver
Control surface settings
Mackie Control
Connecting an R24 to a computer
for the rst time
1
2
3
❷
• To use the R24 as an audio interface for DAW
• Download the latest R24 audio driver from the
Install the ZOOM R16/R24 Audio Driver on
the computer.
☞
Ref: Cubase LE5 Startup Guide
Connect the R24 to the computer.
Set and connect the R24
See "Connecting and setting the R24" on the next page.
Make DAW software settings
Device settings
Control surface settings
NOTE
software (for example, Cubase LE 5) it is neces-
sary to install the ZOOM R16/R24 Audio Driver.
Install it correctly according to the directions
given in the included installation guide.
ZOOM website (http:// www.zoom.co.jp).
110 110