Using The Counter And Marks To Locate - Zoom R24 Operation Manual

Using the counter and marks to locate

The counter shows the recording or elapsed time in hours: minutes: seconds: milliseconds
and bars–beats–ticks (1/48 beat). Set marks in a project to locate to them quickly.
Locate using the counter
To prepare, stop the recorder, select the
project and start from the Top Screen.
1
Select the hours: minutes: seconds or
bars–beats–ticks.
Bars beats ticks
2
Change the values.
NOTE
You cannot change the counter this way during re-
cording or playback.
HINT
• After Step 2, you can start playback from the set
counter position.
• Mark icon display
• Mark zero (
(project beginning) and cannot be changed.
• If you add a mark at a time earlier than an
existing mark, all the following marks will be auto-
matically renumbered in order.
• One project can have a maximum of 100 marks,
including the zero mark.
33
Change item
Hours: minutes: seconds: milliseconds
Change numbers
Mark 03 shown set at 10 minutes,
08 seconds, 15 milliseconds
Mark set at current
counter position
N o m a r k s e t a t
counter position
) is always set at counter 0
Add a mark
Add a mark using the counter
1
Start from the top screen. Set the counter
to the desired mark position.
2
Press
Add a mark during recording/playback
1
During recording or playback
2
Press
Change unit
or digit
Mark icon
Mark number