Table of Contents
Advertisement
Adjust effect parameters
Select a parameter and set it.
HINT
• None of the modules in "Empty" patches have
been set yet.
•
The level of
the ZNR module can be adjusted on
the TOTAL module screen.
• You can individually edit the modules arranged in
the L/R Channels of the DUAL MIC ALGORITHM.
The left channel is selected when "L" appears in
the effect module name and the right channel is
selected when "R" appears.
• Each channel of the 8xCOMP EQ algorithm has its
own high pass filter, compressor and EQ that can
be independently turned on/off and adjusted.
Check the current channel by looking at the
number shown at the end of the effect module
name.
Change the name (insert effect)
1
Select
Select RENAME.
parameter
Change
value
2
Change the name.
NOTE
• You cannot edit an algorithm itself, including
the combination and arrangement of its effect
modules.
• When you turn an effect module OFF, all its
settings, including the type and parameters are
disabled.
• When using the 8xCOMP EQ effect, you cannot
turn it ON/OFF for all channels at once. You must
set it for each channel separately.
• You cannot turn off TOTAL modules.
• The 8xComp EQ algorithm does not include a
ZNR module.
• If you switch to another patch without saving
a patch that has been edited (showing the 'E'
mark), changes will be lost. Please refer to the
next page for how to save patches.
Press
Press
Change menu
Move cursor
Change character
Delete character
Insert character
84
Advertisement
Table of Contents
