Table of Contents
Advertisement
Adjust the input sensitivity,
STEP 4
monitoring level and output
1
Adjust the input sensitivity (GAIN)
Adjust the GAIN of each
INPUT so that their
PEAK indicators blink
occasionally.
2
Adjust the recording level
The red (0 dB) indicator of
the level meter should not
light when you apply an insert
effect to an INPUT. Adjust the
patch level, for example, if
necessary.
3
Adjust the monitoring level
NOTE
• If an input signal distorts during recording, refer
to STEP 4 and adjust the input sensitivity and
recording level.
• After recording has completed, the "Please wait"
pop-up will be displayed. Do not turn the power
OFF or take the SD card out while this pop-up
is open. Doing so could damage data or cause
other problems.
☞
Ref: Recording methods in detail
Using insert effects
Adjust the monitoring
level of an instrument
with the fader of the
track it is being recorded
on. (INPUT 1 would be
track 1, 9 or 17, for
example.)
P17~
P81
STEP 5
Record—Complete—Play
Recording
1
While pressing
move to the beginning.
2
Press
and then
recording.
3
Start performing.
4
Press
to stop recording.
Playback
1
Press the status key to end recording
standby and make the light green.
When green, playback is possible
The track changes from recording standby
(red) to playback standby (green).
2
While pressing
move to the beginning.
3
Press
to start playback.
4
Press
to stop playback.
press
to
to start
Counter starts
Press repeatedly
press
to
8
Advertisement
Table of Contents
