Installing A Mini Pcie Card; Removing The Keyboard Matrix & Controller Pcb; Figure 17 Removing Thek; Eytop Matrix - Cybernet ZPC-GX31 User Manual

ZPC-GX31 User Guide
3.4.4

Installing a Mini PCIe Card

1. Remove the Keytop as instructed in section 3.1.2.
2. Remove the Phillips screw in H1.
3. Insert the Mini-PCIe card at a 45 degree angle into the Mini PCIE 1 slot and
press down until level with the mounting hole at H1.
4. Replace the Phillips screw into H1. .
5. Replace the Keytop as instructed in section 3.1.2.
6. Replace the small plastic cover on the outside of the Keytop to the left of the
PCI slot blanking plate with the Phillips screw provided.
7. Install the drivers from the CD provided with the card.
3.5 Removing the Keyboard Matrix & Controller PCB
1. Remove the Keytop as instructed in section 3.1.2.
2. Remove keyboard controller board and unfasten the two flex cables.
3. Remove CD/DVD drive if present.
4. Remove six Phillips screws to release keytop matrix.
20
Figure 17 Removing the Keytop Matrix
H a r d w a r e I n s t a l l a t i o n a n d R e p l a c e m e n t