Change [Set] Password; Clear Cmos - Cybernet ZPC-GX31 User Manual

4.7 Change [Set] Password

The Password utility sets the password. The ZPC-GX31 is shipped with the password
disabled. If you want to change (or set) the password, you must first enter the current
password, (if adding one for the first time, just press <Enter> when asked for the
current password), then, at the prompt, enter your new password. The password is
case sensitive. You can use up to six alphanumeric characters. Press <Enter> after
entering the password. At the next prompt, confirm the new password by retyping it
and pressing <Enter> again.
To disable the password, select "Clear User/Supervisor Password" press <Enter> [OK]
or [Cancel].
NOTE: If you have established supervisor and user passwords, only
the supervisor password allows you to enter the BIOS Setup Program.
NOTE: If you forget your password, the only way to solve this problem
is to clear the CMOS memory as described below.

4.8 Clear CMOS

You may need to clear the CMOS if you are unable to boot-up the system due to a
forgotten password, an incorrect CPU clock setup, or the need to reset the CMOS
settings to default values after the system BIOS has been updated.
Power off the system and disconnect the power cable.
Locate CMOS recessed pin-hole on the left side of the ZPC-GX31 unit. Insert an
unfolded paperclip to depress the micro switch located inside. This will clear the
CMOS.
Clear CMOS to restore factory default
C M O S S e t u p U t i l i t y
Reset to restart computer
ZPC-GX31 User Guide
27