Table of Contents
Advertisement
3.2 Memory Installation
Maximum system memory supported by the ZPC-GX31 is 4.0 GB. The ZPC-GX31
has two DDR2 Sockets. Memory can be installed using two 240-pin DDR2 DIMM
memory modules. There are no jumper settings required for the memory size or type,
which is automatically detected by the BIOS. Memory modules must meet the
following requirements:
1.
First remove the Keytop as instructed in Section 3.1.2 being careful to follow
instructions regarding the disconnection of power.
2.
To install memory, line up the bottom of the memory with the pattern notches on
the memory slot (it will only go in one way). Depress the memory into the slot
and the clips will click into place.
Install the 240-pin DDR2 modules in any combination as follows:
BANK 0 (DIMM1)
BANK 1 (DIMM2)
Total System Memory
H a r d w a r e I n s t a l l a t i o n a n d R e p l a c e m e n t
DDR2 SPEED 667/800MHz
PC5300 DDR2 667MHz
PC6400 DDR2 800MHz
Figure 10 Installing Memory
128/256/512/1024/2048MB
128/256/512/1024/2048MB
128MB – 4GB
ZPC-GX31 User Guide
13
Advertisement
Table of Contents
