Token Ring Installation From Control Panel - Xerox DocuColor 4 Administrator's Manual

B.5 Performing Setup for Token Ring from the Control
Panel
TOKEN RING
ON/OFF [ON]
Select ON to enable Token Ring network communication. Token Ring op-
tions only appear if an optional Token Ring card is installed.
TOKEN RING SPEED
AUTO DETECT/4 M BPS/16 M BPS [AUTO DETECT]
Select AUTO DETECT to automatically detect the speed at which data can
be transferred over the Token Ring network, or optionally specify the speed
of your Token Ring network.
MAX. FRAME SIZE
0.5K/1K/2K/4K [4K]
Use the arrow buttons to select a maximum frame size for Token Ring com-
munication.
The Token Ring frame size must be no greater than the frame size used by
any router or Novell file server on the network.
SOURCE ROUTING
A ON/OFF [OFF]
Select ON to allow the packet to travel to its destination through routers on
the network. The packet's source dictates the route that the packet will take.
REQ ALL ROUTE
ON/OFF [ON]
If source routing is enabled, select ON to allow all routers on the network to
broadcast the presence of the printer, enabling packets from clients on the
network to travel to the printer by any route.
RESP ALL ROUTE
ON/OFF [OFF]
If source routing is enabled and REQ ALL ROUTE is set to OFF, select ON to
allow all routers on the network to broadcast the presence of clients to the
printer; limits packets from clients on the network to travel to the printer to a
specific route.
136