Token Ring Connection - Xerox DocuColor 4 Administrator's Manual

1.5 Ethernet cable connection
Token Ring Support with DocuColor 4 LP/CP
The DocuColor 4 LP/CP supports Token Ring networks with the optional
1
token ring adapter card;
Token Ring PCI PCBA Part# 45000052
Token Ring supports: AppleTalk, TCP/IP, and IPX networks simultaneously.
Fiery WebTools, WebSpooler, and Web Downloader are also accessible from
the token ring environment.
Printing types supported: IPX/SPX, SMB, TCP/IP, LPR
All configurations for the above printing methods are the same as 10/100
based networks setup, only IP subnets within their respective segments will
change according to the particular LAN configurations.
Token Ring Installation
Be sure machine is turned off and power is unplugged! Also be sure to
properly ground yourself, as you will be working with sensitive electrostatic
equipment. Facing the front of the machine, pull off the right side panel
located near the existing Ethernet port on the rear of the machine. Insert the
Token Ring board, in the respective PCI slot. Secure the board with the two
screws provided with the card. Close the cover, and boot the system. Go
into systems setup, I/O Port Setup, and disable Ethernet, and enable Token
Ring. Ethernet must be turned off, and should not run simultaneously with
Token Ring. Configure token ring port speed, 4, 16, or auto detect. Proceed
with your local LAN configuration setup.
To use thicknet cable:
To use UTP cable for 100BaseT or 10BaseT:
14
With the DocuColor 4 LP/CP turned off, connect the thicknet cable
connector to the AUI connector on the back of the DocuColor 4 LP/CP.
Press on the latch to lock the connector.
Configure network servers for printing and then proceed to "Setting up
the Print Functions".
With the DocuColor 4 LP/CP turned off, connect the RJ-45 cable
connector to the RJ-45 socket on the back of the DocuColor 4 LP/CP.
Configure network servers for printing and then proceed to "Setting up
the Print Functions".