Panasonic AJ-PG50 Operating Instructions Manual page 65

SSID Connection Destination List
a: Selection state
b: SSID
c: Presence/absence of connection history
d: Encryption method
e: Signal strength
• Display is in order from the strongest signal.
• The SSID with the check mark for the selection state is the selected SSID.
• The H indication for the presence/absence of connection history indicates an SSID for which connection history is stored.
Even if a connection destination is out of range, the SSID is displayed on the last row of the list.
Use the up or down cursor to select an SSID and press the [SET] button.
4G/LTE Mode
These settings are for connecting with a 4G/LTE USB modem.
1
Select "4G/LTE" in the "I/F SETUP" - "NETWORK" - "NETWORK SEL" (➝ page 98) menu setting.
When you change these settings, restart the unit if necessary.
2
Check the network connection.
Check whether the connection between the unit and the 4G/LTE network has been established.
If the network connection is correctly established, the network status icon at the top right of the thumbnail screen turns yellow
and you can use the application for using the network (FTP Client Function). (➝ "Using FTP Client Functions" page 69)
Wired LAN Settings
These settings are for connecting to a computer via a wired LAN.
1
Select "LAN" in the "I/F SETUP" - "NETWORK" - "NETWORK SEL" (➝ page 98) menu setting.
When you change these settings, restart the unit if necessary.
2
Configure each item in the "I/F SETUP" - "NETWORK" - "LAN PROPERTY" (➝ page 98) menu setting as nec-
essary.
DHCP and DHCP SERVER are exclusive settings.
MAC ADDRESS: MAC address of the wired LAN (This cannot be changed.)
DHCP: Set whether to use automatic assignment by DHCP (ENABLE: Use automatic assignment / DISABLE: Do not use
automatic assignment) (Factory default setting: ENABLE)
IP ADDRESS: IP address (Factory default setting: 192.168.0.1)
SUBNET MASK: Subnet mask (Factory default setting: 255.255.255.0)
DEFAULT GATEWAY: Default gateway (Factory default setting: 192.168.0.254)
PRIMARY DNS: Primary DNS server setting (Factory default setting: 0.0.0.0)
SECONDARY DNS: Alternate DNS server setting (Factory default setting: 0.0.0.0)
DHCP SERVER: Set whether to use the DHCP SERVER function (ENABLE: Use the DHCP SERVER function / DISABLE: Do
not use the DHCP SERVER function) (Factory default setting: DISABLE)
a b c d
Main Mode: Using the Unit Connected to a Network
e
65