Panasonic AJ-PG50 Operating Instructions Manual page 116

Item Message
CANNOT REPAIR IN
SELECTION!
CANNOT REPAIR!
CANNOT SAVE! FILE
NAME IN USE
CARD FULL!
INVALID VALUE!
LACK OF CAPACITY!
MISSING CLIP!
NO CARD!
NO FILE!
NO COPY TO SAME
CARD!
Thumb-
nail NO INPUT!
NO SD CARD!
NOT SELECTED!
SAME CLIP IS
SELECTED!
TOO MANY CLIPS!
UNKNOWN CONTENTS
FORMAT!
UNKNOWN DATA!
USER CLIP NAME
MODIFIED!
WRITE PROTECTED!
116
For Long and Trouble-Free Operation: Warning System
Description
Some of the selected clip could not be repaired. Check the selected content.
Content that cannot be repaired is selected.
A configuration file with the same file name al-
ready exists on the SD memory card.
The P2 card or SD memory card is full.
The entered data is invalid.
There is not enough recording space left on the
card.
A shot mark cannot be added to a clip that spans
multiple P2 cards if all of the segments are not
available.
No P2 card or SD memory card is inserted.
The designated file does not exist.
Copying is not possible because the copy
source and copy destination are the same.
No data is input.
No SD memory card is inserted.
An attempt was made to delete when no clip was
selected.
The selected clips contain multiple copies of the
same clip (duplicated by copying).
Too many clips are selected.
This warning is for when the version of the con-
tent is not compatible with the unit.
• The metadata character code is invalid.
• There is a problem with the data in the file.
Characters need to be deleted when the counter
value is added to the clip name.
The P2 card or SD memory card is write protect-
ed.
Measure
Check the selected content.
Save the file under a different name.
Insert media with sufficient free space.
Enter data in a valid range.
Insert a card with sufficient recording space.
Insert all of the P2 cards on which the clip was record-
ed.
Insert compatible media.
Check the file.
Copy to a card that does not contain the selected
clip.
Input data and then set the setting.
Insert an SD memory card.
Select the clip you want to delete.
Multiple copies of the same clip (duplicated by copy-
ing) cannot be simultaneously copied. Deselect all of
the selected clips that are identical copies.
Reduce the number of selected clips.
Match the device and content versions.
• Use UTF-8 for the metadata character code.
Use the viewer to enter the correct characters.
• Create the file again.
Only up to 100 bytes can be saved for the combina-
tion of the user clip name and counter value so char-
acters are deleted automatically when the total
exceeds that amount.
Insert write-enabled media.