Panasonic AJ-PG50 Operating Instructions Manual page 115

Displayed message
SIMUL REC WARNING < >
LAN ERROR
INVALID TC MODE
INT SG
NO INPUT
INVALID INPUT FORMAT
HDCP EXISTED
Display of thumbnail warning information
Item Message
CANNOT ACCESS!
CANNOT CHANGE!
Thumb-
CANNOT DELETE!
nail
CANNOT FORMAT!
CANNOT RE-CONNECT!
Displayed when an error occurs with one of the cards during simultane-
ous recording. ( is the slot number mark for indicating where the error
occurred.)
Recording will stop on the card on which the error occurred, but will con-
tinue on the other card.
Displayed when the LAN connection or disconnection failed. To continue
operation, turn the power off and then back on.
If the message is displayed again, consult with your dealer.
Displayed during playback when the time code has been recorded in
drop frame mode. The video output is distorted and audio output is muted
at the drop point of the time code. Check the playback clip.
Playing back a 24P frame-rate clip requires that the time code be record-
ed in non-drop frame mode.
Displayed when the time code in an HD SDI input is in the drop frame
mode during EE or recording. Normal recording will not be possible under
these conditions.
Displayed for the first two seconds when the [REC] button is pressed to
switch to EE mode while "INT SG" is selected in the "I/F SETUP" - "VIDEO"
- "INPUT SEL" menu setting.
If there is no input signal to the connector selected in "INPUT SEL" (ex-
cluding analog audio), this is displayed for 2 seconds after you press the
[REC] button to switch to EE mode.
Displayed when the input signal of the connector selected by "INPUT SEL"
is a signal that cannot be received. The input signal is muted.
Displayed when an HDCP signal is detected while the HDMI input is se-
lected. Note that recording is not possible when an HDCP signal is de-
tected. SDI/HDMI output is also not possible.
Description
The data cannot be accessed because, for ex-
ample, the content is corrupted.
The thumbnail cannot be changed for a text
memo that is indicated by a gray
the thumbnail could not be generated.
Deletion is not possible because the content ver-
sions do not match.
Formatting is not possible because of a problem
with the P2 card, etc.
Clip reconnection is not possible because, for
example, content that is not a clip spanning mul-
tiple cards is selected.
Description
Restore the media and clips to their normal states be-
fore access.
Edit the settings or content to enable thumbnail dis-
because
play.
Match the device and content versions.
Check the P2 card.
Check the selected content.
For Long and Trouble-Free Operation: Warning System
Deck operation
Operation
continues
STOP
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Measure
115