Panasonic AJ-PG50 Operating Instructions Manual page 113

Displayed message
BATTERY NEAR END
SLOT SEL INVALID
BUSY
FAN STOPPED
BACKUP BATT EMPTY
REC WARNING
<FRAME SIGNAL>
TEMPORARY PAUSE
IRREGULAR SIG
REC WARNING
<PULL DOWN>
(When error occurs during recording)
REC WARNING
PULL DOWN ERROR
(When error occurs not during recording)
REC WARNING
<OVER MAX# CLIPS>
Description
The voltage of the battery is low.
Replace the battery.
Displayed if the [SLOT SEL] button (when assigned to a [USER] button) is
pressed when it is not possible to switch the P2 card recording slot.
Displayed while the clip information is being read or when the clip configura-
tion has changed. No operations can be performed while BUSY is on the
screen.
[Cause]
• A card has been inserted or removed.
• Updating is in progress
• Recording post processing is in progress
• Other causes
Displayed when the fan motor is stopped.
The power turns off automatically 30 seconds after the message appears.
Also a beep sound is output for 30 seconds. Immediately stop using the
unit and then turn off the power and contact your dealer.
Displayed when a drop in the backup battery voltage for the internal clock
is detected at power-on.
Refer to "About the battery of the internal clock" (➝ page 25).
Displayed when a video or audio error occurs during recording.
To continue operation, turn the power off and then back on.
If the input signal becomes disrupted during recording, recording will
continue but disrupted video will be recorded. Check the signal input to
the unit.
Even if recording is continued, video and sound will be recorded correctly
when the signal returns to normal.
Displayed when a video or audio error occurs during recording, and re-
cording is paused.
Recording will be resumed automatically when the signal returns to normal.
The clip will be divided. The time code may become non-continuous.
When recording in AVC-G format, remove and reinsert the card after re-
cording is complete, and repair the clips for which "
played.
The video pull-down sequence and TC values are not synchronized.
Check the signal.
Displayed when an attempt was made to record a clip that would result in
the upper limit for the total number of clips being exceeded on one P2
card.
Replace the P2 card or delete unnecessary clips.
For Long and Trouble-Free Operation: Warning System
Deck operation
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Continues
Recording
pauses
" (yellow) is dis-
Continues
STOP
113