SMART Board M685ix2 Configuration And User's Manual page 63

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
All responses from the projector are terminated with a command prompt. Wait until you
l
receive the command prompt indicating that the system is ready for another command
before you continue.
The room control feature of the projector is always on.
l
To configure your computer's serial interface
1. Turn on your computer, and then start your serial communications program or terminal
emulation program.
2. Connect your computer to the serial connection cable connected to the projector.
3. Configure your serial interface settings using the values in the previous table, and then press
ENTER.
The > character appears as a command prompt.
NOTE
If no message appears or an error message appears, your serial interface configuration isn't
correct. Repeat step 3.
4. Type commands to configure your settings.
NOTES
To see a list of commands available in the current operating mode, type ? and then
o
press ENTER.
If you're using a terminal emulation program, turn on your program's local echo setting
o
to see characters as you type them.
55 smarttech.com/kb/170548