SMART Board M685ix2 Configuration And User's Manual page 24

CHAPTER 3
USING YOUR INTERACTIVE WHITEBOARD SYSTEM
Setting Use
H-Position Moves the horizontal position
of the source video left or right
from 0 to 100 (relative to the
projected image).
V-Position Moves the vertical position of
the source video up or down
from -5 to 5 (relative to the
projected image).
White Peaking Adjusts the image color
brightness from 0 to 10 while
providing more vibrant white
shades.
Degamma Adjusts the color performance
of the display from 1 to 3.
Color Adjusts the Red, Green, Blue,
Cyan, Magenta and Yellow
colors on the projector from 0
to 100 to provide custom color
and luminance output.
Audio menu
Volume Adjusts the projector's volume
amplification from -20 to 20.
Mute Mutes the projector's audio
output.
Disable Volume Disables the projector's
Control volume control.
Selects one or more speakers
System Output
or other audio device.
16 smarttech.com/kb/170548
Notes
Don't adjust this setting unless you're advised
to by SMART Support.
Apply this setting only after you make all
boom adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
Don't adjust this setting unless you're advised
to by SMART Support.
Apply this setting only after you make all
boom adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
A value closer to 0 creates a natural image
and a value closer to 10 enhances brightness.
The default is 10.
The default is 2.
Each color has a default value of 100.
Adjustments to the color settings register
under the User mode.
The default is 0.
The default is off.
If you mute the projector's audio output and
then increase or decrease the volume, the
volume is restored automatically. You can
prevent this from happening by disabling the
volume control.
Select Line Out+Speaker, Line Out Only or
Speaker Only.