SMART Board M685ix2 Configuration And User's Manual page 77

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
Setting Use
Image Adjustment menu
Display Mode Indicates the projector's
display output
(SMART Presentation,
Bright Room, Dark Room,
sRGB and User).
Brightness Adjusts projector brightness
from 0 to 100.
Contrast Adjusts the difference
between the lightest and
darkest parts
of the image from 0 to 100.
Frequency Adjusts the display data
frequency of the projected
image from -5 to 5 to match the
frequency of your computer's
graphics card.
Tracking Synchronizes your projector's
display timing with your
computer's graphics card from
0 to 63.
H-Position Moves the horizontal position
of the source video left or right
from 0 to 100 (relative to the
projected image).
V-Position Moves the vertical position of
the source video up or down
from -5 to 5 (relative to the
projected image).
White Peaking Adjusts the image color
brightness from 0 to 10 while
providing more vibrant white
shades.
69 smarttech.com/kb/170548
Notes
The default is SMART Presentation.
The default is 50.
The default is 50.
The default is 0.
This setting applies to VGA inputs only.
This setting applies to VGA inputs only.
Don't adjust this setting unless you're advised
to by SMART Support.
Apply this setting only after you make all
boom adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
Don't adjust this setting unless you're advised
to by SMART Support.
Apply this setting only after you make all
boom adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
A value closer to 0 creates a natural image
and a value closer to 10 enhances brightness.
The default is 10.