SMART Board M685ix2 Configuration And User's Manual page 27

CHAPTER 3
USING YOUR INTERACTIVE WHITEBOARD SYSTEM
Setting Use
Opens a sub-menu that
USB Source
enables you to select the
Select
video input on your projector
and the USB receptacle on the
ECP.
Network menu
Network Activates the projector's RJ45
connector and network
features.
Status Displays the current network
status (Connected,
Disconnected or Off).
DHCP Displays the status of the
network's Dynamic Host
Configuration Protocol (DHCP)
as On or Off.
Password E-mails the network password
Reminder to the predefined e-mail
recipient.
IP Address Displays the projector's current
IP address in values between
0.0.0.0 and 255.255.255.255.
Subnet Mask Displays the projector's subnet
mask number in values
between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector's default
network gateway in values
between 0.0.0.0 and
255.255.255.255.
19 smarttech.com/kb/170548
Notes
The defaults are:
HDMI-1, USB 1
l
HDMI-2, Disabled (no associated USB
l
input)
VGA-1, USB 2
l
The default is off.
The default is on.
On enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off enables an administrator to assign an IP
address manually.
See Web page management on page 43 to
set up a destination e-mail address.
To change the projector's IP address, use the
RS-232 connector or use a DHCP server to
assign a dynamic IP address, and then set a
static IP address using the network remote
management feature (see Remotely
managing your system through a network
interface on page 43).