Main Fuse; Acg Fuse - TOHATSU BFT 115A Owner's Manual

If the fuse is blown, check the
cause, then replace the fuse with a
spare fuse of the same rated
capacity. Unless the cause is found,
the fuse may blow again.

Main Fuse

<Replacement>
A spare fuse is located on the reverse
side of the junction box lid.
1. Stop the engine.
2. Remove the engine cover.
3. Remove the junction box lid and
pull the old fuse out of the clip with
the fuse puller supplied in the fuse
holder.
4. Push a new fuse into the clips.
5. Reinstall the junction box lid, and
the engine cover.
6. Reconnect the battery.
DESIGNATED FUSE:
10A, 15A, 30A

ACG Fuse

FUSE (100A)
FUSE HOLDER
SPARE FUSE (100A)
Disconnect the battery cable at the
battery terminal before checking or
replacing the ACG fuse.
MAINTENANCE
<Replacement>
A spare fuse is located in the fuse
holder.
1. Stop the engine.
2. Remove the engine cover.
3. Remove the junction box lid (see
page 102).
4. Remove the old fuse by removing
two 5 mm screws.
5. Install a new fuse with "100A".
6. Reinstall the junction box lid, and
the engine cover.
7. Reconnect the battery.
DESIGNATED FUSE:
100A
103