TOHATSU BFT 115A Owner's Manual page 92

4. Fold down the upper part of the
under cover grommet without
removing it from the idle port.
SPARK PLUG COVER
BOLTS
5. Remove the two bolts with the 6
mm hex wrench, and remove the
spark plug cover.
6. Use a hex. wrench to remove the
bolt holding the ignition coil. Move
the ignition coil to a position that
allows to remove the wire
connector easily.
IGNITION COIL
LOCK TAB WIRE CONNECTOR
7. Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
8. Remove the ignition coil by pulling
it up slightly. Take care not to give
an impact or drop the ignition coil.
Replace the ignition coil if dropped
it.
BOLT
SPARK PLUG
WRENCH
9. Use the spark plug wrench and 19
mm eye wrench to remove the
spark plugs.
MAINTENANCE
19 mm EYE
WRENCH
89