TOHATSU BFT 115A Owner's Manual page 101

MAINTENANCE
CUP
O-RING
(Replace)
WATER
SEPARATOR
SUSPENSION STRAP
CUP
3. Pinch the fuel tubes with tube clips
to prevent fuel leakage.
4. Remove the three screws and
separate the water separator cup
from the body.
5. Thoroughly clean the water
separator cup.
98
WATER SEPARATOR BRACKET
WATER SEPARATOR
SUSPENSION
STRAP
ALIGNMENT
POSITION WATER
SEPARATOR
CUP
6. Reassemble the water separator
body and the cup. Use a new
O-ring.
TIGHTENING TORQUE:
3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
7. Align the center of suspension
strap with the screw position and
install the water separator
assembly.
8. Reinstall the water separator in the
reverse order of removal.
9. Squeeze and release the priming
bulb to fill the vapor separator, and
check for fuel leaks. Repair any
fuel leaks if necessary.
If the buzzer sounds, water or
sediment accumulation is found to be
caused by excessive water or
sediment accumulated in the water
separator cup, inspect the fuel tank.
Clean the fuel tank if necessary.