Engine Oil - TOHATSU BFT 115A Owner's Manual

STORAGE
FRONT BRACKET CLAMP
DRAIN SCREW
DRAIN TUBE
VAPOR SEPARATOR
1. Remove the engine cover.
2. Unhook the drain tube from the
front bracket clamp.
3. Set the end of the tube toward the
outside of the engine undercase.
Draining the fuel becomes easier
when the front end of the drain tube
is as low as possible.
4. Loosen the vapor separator drain
screw.
108
5. Tilt up the outboard motor.
6. When the gasoline starts to flow
out of the drain tube, tilt up the
outboard motor and hold it in the
position until the gasoline stops
flowing. After draining the
gasoline completely, return the
outboard motor to the vertical
position.
7. After draining thoroughly, tighten
the drain screw securely.
8. Clamp the drain tube on the front
bracket clamp.

Engine Oil

1. Change the engine oil (see page
85).
2. Remove the spark plugs (see page
87), and remove the clip from the
emergency stop switch.
3. Pour 1 – 2 teaspoons (5 – 10 cm
of clean engine oil into the
cylinder.
4. Rotate the engine a few revolutions
to distribute the oil in the cylinders.
5. Reinstall the spark plugs (see page
90).
3
)