Multiline; Line Key Configuration - Siemens optiPoint 410 entry Administrator's Manual

Multiline

Line key configuration

In line overview menu you can configure lines and an assign lines to keys.
It suffices to assign one line to a key for to go in multiline operation.
Phone path
Parameter
(Menu ! page 148)
Line
(not applicable)
!
Seite 196
Key Label
(not applicable)
!
page 192
Address of
record
(not applicable)
!
page 199
Realm
(not applicable)
!
page 201
Primary line
(not applicable)
!
page 201
Ring
- 02=System
!
page 201
- 28=Keyset
- 01=Line
select a line
- 2=Ringer setting
(Read only)
Extended Administration
Web Interface path
(Menu ! page 110)
- Funcktion keys
- Phone
or
- Key module
- Select a key with EDIT
a configuration dialog appears
- Select:line
(A key with line is ready for con-
figuring)
Line key configuration dialog
- Key Label
(enter a name for the line key –
only with optiPoint 420)
Line key configuration dialog
- Address of record
(enter e.g. phone number)
Line key configuration dialog
- Realm
(enter IP address)
Line key configuration dialog
- Primary line
(mark as primary if required)
Line key configuration dialog
- Ring
(enable/disable)
67