Configuring Date And Time; Sntp Is Available, But No Automatic Access By Dhcp Server; No Sntp Server Available - Siemens optiPoint 410 entry Administrator's Manual

Extended Administration

Configuring Date and Time

If the DHCP server in your network provides information about the SNTP
server access, the date and time is automatically shown on the phone.
If the DHCP server in your network does not provide a SNTP address you
have to set the SNTP address manually.
If no SNTP server is in your network you have to configure the date and
time manually.

SNTP is available, but no automatic access by DHCP server

Parameter
SNTP Address
Timezone Offset
1

No SNTP server available

Parameter
Date/Time
Daylight Saving
Time
66
If SNTP is being used, any user specified value for Time and Date
will be overwritten when the next SNTP update occurs!
Phone path
(Menu ! page 148)
- 04=Date/Time
!
page 219
- 1=SNTP IP addr
(change IP address
- 04=Date/Time
!
page 223
- 2=Timezone offset
(change timezone offset)
or host name (if DNS is applicable
Phone path
(Menu ! page 148)
Y
- 2=Configuration
!
page 173
- 03=Date/time
(select a date format and
change date and time)
Y
- 2=Configuration
- 14=Daylight Saving
!
page 173
(switch on/off)
Web Interface path
(Menu ! page 110)
- Time and date
- SNTP server IP address or DNS
1
) name
(enter IP address
- Time and date
- Time zone offset
(enter timezone offset)
!
page 41)
Web Interface path
(Menu ! page 110)
- Time and date
- Local time/Date
(enter Local time, enter/select
Date)
- Time and date
- Daylight saving
(activate/deactivate checkbox)
*
)