Install Wall Switch Kit (Recommended) - Valor 1600IN Installation & Owner's Manual

Install Wall Switch Kit (recommended)

CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR THE BATTERY BOX
until the wires are connected to the burner
control unit as short-circuit could result in the
destruction of the electrical components.
The wall switch kit is provided with this appliance. It is
connected to the receiver in the fi replace. The receiver is
located on the left side of the appliance, left of the control
valve behind the appliance's front panel. It is maintained
in position with Velcro bands. The battery box is located
in a sliding carrier to the right hand side of the appliance
behind the front panel.
1. Decide where the switch is to be installed on the
wall. Install an electrical outlet box or mud ring as
required (not supplied) to house the switch controls.
2. Thread the switch wire through an access hole in
the appliance.
CAUTION
Do not run the switch wire over the top of the
fi rebox. Route the wire so it does not contact the
fi rebox.
3. Detach the receiver and pull it out. Pull out the
battery box from its sliding carrier. Remove the
batteries from the receiver or battery box if they
contain any. You can remove the ignition wire to
improve access to the receiver.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box!
This could cause a short circuit to the receiver.
4. Take the switch wire and plug it into the receiver's
connection slot as indicated (the other slot should
already be fi tted with the valve's wire harness
connector). See diagrams below.
IMPORTANT: The connection can only be done
one way. Do not force it or damage the pins!
5. On the outside of the fi replace, run the switch wire
into the outlet box. Use insulated type staples to
secure the wiring to framing.
6. Plug the wire into the switch plate and to the
outlet box.
Installation
Receiver
The receiver and battery box carrier are located inside the
front panel of the appliance (valve access side shown).
Wall Switch Harness
Valve Wire Harness
Ignition Wire Connection
(spade type connector)
Be careful when removing
and reinstalling: not to bend
or break the spade connector
QUALIFIED
INSTALLER
Battery box in carrier
IMPORTANT: The connection
can only be done one way.
Do not force it or damage the
pins on the receiver box!
Ignition Wire
Antenna
47