Install Remote Battery And Wall Switch Kit Rbwsk (Required) - Valor 1500INO Installation & Owner's Manual

Install Remote Battery and Wall Switch
Kit RBWSK (required)
The Remote Battery and Wall Switch Kit is provided
with this appliance. It is connected to the receiver in the
fi replace.
Material required
• 4 AA 1.5V alkaline batteries supplied with the engine
• Remote Battery and Wall Switch Kit, which contains:
◊ 1 Wall Switch
◊ 4 Screws
◊ 1 Battery Holder
◊ 1 Plate with magnets
◊ 1 Battery Cover assembly
◊ 1 Harness assembly - 25 ft
◊ 1 Junction Box
◊ 1 Cover plate and Screws
◊ 1 Cable tie
Installation
The receiver is located on the left side of the appliance,
left of the control valve behind the appliance's front
panel. It is maintained in position with Velcro bands.
1. Pull out the receiver from its location to connect the
battery holder and wall switch.
2. Feed the 'white connector end' of the harness
assembly through side holes in fi replace liner body
to receiver. Ensure suffi cient harness length to
allow for removal of receiver. Note - coil up any
extra harness at fi replace end.
3. Connect switch to auxillary 5-pin junction and
power connection to jack.
Installation
4. Run harness assembly to mounted position of
junction box, securing harness to framing using
insulated staples (not included)
5. Feed harness assembly through a restrain on
rear of junction box, feeding through until harness
sheath is pinched by retainer and providing
suffi cent length to make connection to rear of
switch and battery holder.
6. Secure junction box to the mounting surface using
appropriate fasteners (not included)
7. Align molex connection on switch cable of harness
assembly and connect to switch.
Do not run the switch wire over the top of the
fi rebox. Route the wire so it does not contact the
fi rebox.
QUALIFIED
INSTALLER
CAUTION
47