Managing Close Call Hits; In Close Call Only Mode; In Close Call Hold Mode - Uniden BCD96P2 Owner's Manual

MANAGING CLOSE CALL HITS

In Close Call Only Mode

When the scanner detects a Close Call signal, 'Close Call' appears for the length of time set in
Close Call Pause (or until the signal is lost if longer).
The band number will blink under the band that the hit was found in.
The frequency is displayed for the (+) delay time set in Search/Close Call Options (even if it's
gone).
To hold on a CC hit press HOLD. Press HOLD again to resume. See Close Call Hold Mode.
To store a frequency press E/
To cancel a CC hit turn the scroll control.
To toggle CC bands off or on press the number key for each band.
To toggle the lock out status of a frequency press L/O.
To view the last CC hit press HOLD. Press HOLD again to resume.
To toggle the attenuation on or off (for all bands) press
To toggle the modulation (for all bands) press
To exit CC only press SQ.
While Scanning or Searching with Close Call Override set to On, when the scanner detects a
Close Call signal, the scanner overrides the current audio and goes to the Close Call hit.
'Close Call' appears for the length of time set in Close Call Pause (or until the signal is lost if
longer). If you do not press 'HOLD', the scanner will return to scanning after 'pause' times out.
The signal is audible and displayed for the (+) delay time set in Search/Close Call Options (even if
it's gone).
Quickly press HOLD to stay on the frequency. Press HOLD again to resume.
While Scanning or Searching with Close Call Override set to Off, when the scanner detects a
Close Call signal, the scanner does not override the current audio.
'CC Found!' and 'Press Func Key' appear for the length of time set in Close Call Pause. If you do
not press 'Func', the scanner will return to scanning after 'pause' times out.
Press to listen to and display the frequency for the (+) delay time set in Search/Close Call
Options (only if it's still there).
Quickly press HOLD to stay on the frequency. Press HOLD again to resume.

IN CLOSE CALL HOLD MODE

To store a frequency press E/
To toggle the lock out status of a frequency press L/O.
To start a 'Quick Search' at the current frequency turn the scroll control then press HOLD.
To turn Intermediate Frequency Exchange on or off press
To check for a repeater frequency press
then see Storing a Displayed Frequency.
then 9(MOD).
then see Storing a Displayed Frequency.
then press and hold 8(REV).
then 7(ATT).
then 4(IFX).
91