Uniden BCD96P2 Owner's Manual page 100

2. Enter the tone and press E/
3. Scroll to 'Edit Tone B' and press E/
4. Enter the tone and press E/
5. Press MENU to return.
6. Scroll to 'Set Delay Time' and press E/
7. Scroll to one of 3 settings and press E/
Off - the scanner resumes standby as soon as the carrier drops after a page.
1-30 - (seconds): the scanner resumes standby mode after the carrier drops and the
selected time expires.
Infinite - you must press HOLD after a page to resume standby mode.
8. Scroll to 'Set Alert' and press E/
9. Scroll to 'Set Alert Tone' and press E/
10. At 'Set Tone' scroll to the alert (Alert 1-9 or Off) and press E/
11. At 'Set Level' scroll to 'Level 1-15 or Auto' (the scanner sets the alert beep to the master
volume level) and press E/
12. Scroll to 'Set Alert Light' and press E/
13. Scroll to Off, Blue, Red, Magenta, Green, Cyan, Yellow, or White and press E/
14. At 'Set Pattern' scroll to On, Slow Blink, or Fast Blink and press E/
15. Press MENU to return.
16. Scroll to 'Set Record' and press E/
17. Scroll to On or Off and press E/
18. Press MENU to return then scroll to 'Tone-Out 2' and repeat to program more tones.
19. Press MENU to return.
Using Tone-Out Standby/Search See Setting up Tone-Out first.
96
to save and exit.
.
to save and exit.
.
to save and exit.
.
.
.
.
.
to save and exit.
.
.
.