Searching (Only, Not Search With Scan); Storing A Displayed Frequency (While Searching) - Uniden BCD96P2 Owner's Manual

6. Enter the new frequency you wish to start at then press HOLD to set the new starting
frequency.
Press HOLD again to release hold mode and start searching. Then see Searching.
7.
8. Press SCAN/SEARCH to exit.

Searching (only, not Search with Scan)

1. To start a search see Quick Search, Service Search, or Custom Search.
2. To toggle search bands on or off for custom searches press the number key of the custom
search.
3. To access (1) search using the programmed search keys press
1(srch 1), 2(srch 2), or 3(srch 3) to start searching.
4. To change search direction or continue searching turn the scroll control back or forward.
5. To hold on a frequency press HOLD. Press HOLD to resume.
6. To step through the frequencies turn the scroll control.
Press HOLD to resume.
7.
8. To store a frequency press HOLD to hold on the frequency.
9. Then see Storing a Displayed Frequency.
10. To toggle the lockout status of a frequency press L/O.
11. To turn Intermediate Frequency Exchange on or off press HOLD to hold on the frequency
then press then 4(IFX). Press Hold to resume.
12. To turn the attenuator on or off for each custom or service search press
7(ATT). (Press and hold 7(ATT) for global attenuation).
13. To check for a repeater frequency press HOLD to hold on the frequency.
14. Press then press and hold 8(REV). Press Hold to resume.
15. To toggle modulation for a search press HOLD to hold on each search.
16. Press 7(ATT) then 9(MOD). Press HOLD to resume.
17. To toggle Close Call modes press SQ(
18. To review and unlock search frequencies press
19. To unlock all frequencies of all search/close call ranges Hold on any search and press and
hold L/O.

Storing a Displayed Frequency (while searching)

To store a displayed frequency into an existing group:
1. Quickly press E/
2. At 'Quick Freq Save?' press .No.
3. At 'Select System' scroll to the system where you want to store the frequency and press
E/ .
4. At 'Select Group' scroll to the group where you want to store the frequency and press E/
After storing the frequency, you will be at the 'Edit Channel' menu to complete the settings for the
new channel.
If you don't want to edit the channel settings or are done editing the channel, press L/O to return
to searching.
).
.
then the search key
then press
then L/O.
.
87