Programming Frequencies/Tgids; Quickly Storing A Conventional Frequency - Uniden BCD96P2 Owner's Manual

3. At 'Set Longitude' press E/
4. At 'Set Range' press E/
5. Enter the range (0.5 to 125 in 0.5 steps) and press E/
6. At 'Set GPS Enable' press E/
7. Scroll to On or Off and press E/
8. Press MENU to return.
Set Lockout determines whether a group will be scanned or not (even if the quick key for the
group is turned on). 'Temporary L/O' means until you cycle power. The default setting is Unlocked.
1. Scroll to 'Set Lockout' and press E/
2. Scroll to 'Unlocked', 'Temporary L/O', or 'Lockout' and press E/
3. Press SCAN/SEARCH or L/O to exit.

PROGRAMMING FREQUENCIES/TGIDS

Once you have your Systems built, systems options configured, Sites Created (for trunking
systems), Site Options configured, and Groups Created, you can (finally) program your channels.

QUICKLY STORING A CONVENTIONAL FREQUENCY

To Program a Frequency into a 'Quick Save Group' in a 'Quick Save System':
1. In scan mode press HOLD to hold on any channel.
2. Enter the frequency and press E/
At 'Quick Freq Save?' press E/
3.
Note: If the frequency is already stored in the group, 'Frequency Exists Accept? (Y/N)'
appears. Press .No to return.
The scanner will save the frequency in a (created) group called 'Qck Save Grp' in a (created)
system called 'Qck Save Cnv Sys' (with no quick keys assigned) and you will be at the 'Edit
Channel' menu to complete the settings for the new channel. If you don't want to edit the channel
settings or are done editing the channel, press L/O to return to 'Hold' to enter another frequency
or SCAN to exit.
Then see Edit Channel Options, Edit Group Options, and Edit Conventional Systems Options to
customize the channel(s), group, and system.
To Program a Frequency into an Existing Group:
1. In scan mode press HOLD to hold on any channel.
2. Enter the frequency and press E/
At 'Quick Freq Save?' press .No.
3.
4. At 'Select System' scroll to the system where you want to store the frequency and press
E/ .
5. At 'Select Group' scroll to the group where you want to store the frequency and press E/
Note: If the frequency is already stored in the group, 'Frequency Exists' Accept? (Y/N)'
appears. Press .No to return.
After storing the frequency, you will be at the 'Edit Channel' menu to complete the settings for the
new channel. If you don't want to edit the channel settings or are done editing the channel, press
L/O to return to 'Hold' to enter another frequency or SCAN to exit.
54
. Enter the longitude and press E/ .
.
.
.
.
.
.
.
.
.
.