Uniden BCD96P2 Owner's Manual page 68

Set Speed Limit (Dangerous Road/Xing only) decides whether the scanner alerts you each
time you approach the location or only when you are traveling above a certain speed. To make the
alert speed-dependent, enter the speed limit for this location. Leave the speed limit blank to be
alerted regardless of your speed. The default setting is '0 mile/h (0 km/h)'.
1. Scroll to 'Set Speed Limit' and press
2. Enter a speed from 0 through 200 mi/km, in 1 mi/km steps and press
Set Lockout the default setting is 'Unlocked'.
1. Scroll to 'Set Lockout' and press
2. Scroll to 'Unlocked', 'Temporary L/O', or 'Lockout' and press
Note: you can also do this in 'Review Location Mode' by pressing L/O.
GPS Display Mode (POI only)
Press GPS to switch to GPS display mode. In this mode, you can see the current location
information as well as information about your position relative to selected POI's.
1. Rotating will select different POI's.
2. Press then 6(DISP) to toggle the Display Modes.
64
.
.
The left side of the 1st line displays the current
direction of travel.
The right side of the 1st line displays the
present time.
The left side of the 2nd line displays the
current speed.
The right side of the 2nd line displays the
elevation of the current location.
The 3rd line is always "OFF" because a POI is
not selected.
to save and exit.
to save and exit.