Uniden BCD96P2 Owner's Manual page 47

a resume after that number of seconds. This setting applies to all channels in the system. You
cannot set the delay on a 'per channel' basis. The default setting is 2 seconds.
1. Scroll to 'Set Delay Time' and press E/
2. Scroll to the desired delay time (-10, -5, -2, 0, 1, 2, 5, 10, or 30 secs.) and press E/
save and exit.
Set Record enables the REC jack for marked channels, no channels, or all channels in the
system. The default setting is Off.
1. Scroll to 'Set Record' and press E/
2. Scroll to one of 3 settings and press E/
All Channel - The scanner sends the audio for all channels in the system to the REC
jack, regardless of the channel's record option setting.
Marked Channel - The scanner only sends the audio for channels that have the record
option turned on to the 'REC' jack.
Off - The scanner does not send any audio from any channel in the system to the REC
jack, even if the record option is turned on for a channel.
Set Audio AGC allows you to turn the AGC feature on or off for the system. See also Adjust Audio
AGC.
1. Scroll to 'Set Audio AGC' and press E/
2. Scroll to 'Analog' and press E/
3. Scroll to 'Digital' and press E/
4. Press MENU to return.
P25 Waiting Time this setting basically gives the scanner time to determine if channels on
conventional systems have digital or analog transmissions. During this time, the scanner will
evaluate the received signal and, if it detects P25 data, will open squelch immediately. If P25 is
not detected before the delay expires, the scanner will open squelch at the end of this delay. This
is to prevent "false decode" problems (digital noise at the beginning of transmissions). The default
setting is 400 ms. This setting only affects conventional channels with an Audio Type set to 'All'.
1. Scroll to 'P25 Wait Time' and press E/
Set the Wait Time from 0 to 1000 ms and press E/
2.
Note: Any analog transmissions will lose the first part of the transmission, up to the wait
time you set here.
To Edit the System Name:
1. Press MENU.
2. At 'Program System' press E/
3. At 'Select System' scroll to the system you want to copy and press E/
4. At 'Edit Name' press E/
To Copy a System:
1. Press MENU.
2. At 'Program System' press E/
3. At 'Select System' scroll to the system you want to copy and press E/
4. Scroll to 'Copy System' and press E/
.
.
to save and exit.
.
to toggle on or off.
to toggle on or off.
.
.
. See Entering Text.
.
.
.
.
.
to
43