Using Startup Keys - Uniden BCD96P2 Owner's Manual

Set Priority sets the priority mode. You can also toggle these modes by pressing PRI in scan
mode.
1. Scroll to 1 of 3 options and press E/
Off - the priority feature is off.
On - the scanner checks conventional priority channels, and priority IDs within systems
that have priority ID enabled.
PRI - appears in the display when you select this mode.
Plus On - the scanner only scans the conventional priority channels.
PRI - flashes in the display when you select this mode.
Set Internval sets how often the scanner will check the priority channels.
1. Scroll to 'Set Interval' and press E/
2. Enter the number of seconds (1-10) and press E/
MaxCHs/PRI-Scan sets the maximum priority channel numbers that are scanned during one
priority scan interrupt. If there are more priority channels than the value you select, the channels
are divided into more than one group and the scanner scans each group in turn. For example,
if you set the maximum channels to 20 and there are 100 priority channels, the scanner checks
those 100 channels in groups of 20 and takes a total of 5 intervals to complete the priority scan.
1. Scroll to 'MaxCHs/PRI-Scan' and press E/
2. Enter the number of number of channels to check (1-100) and press E/
You can program each of your Systems with a Startup Key (0-9) so that when you power up the
scanner and press the key number at the same time, just those Favorites List(s) assigned to the
key will be enabled for scan. Systems are not affected.
To Use a Startup Key:
1. Turn the scanner off.
2. Press & hold the number key that corresponds to the startup key when you turn the scanner
on.
3. Continue holding the number key until the scanner display shows the number of the startup
key configuration.
When you use startup configuration, the scanner checks all systems, sites, and search ranges
and:
• All systems, sites, or search ranges that do not have a startup key assigned will be scanned
the way they were when you last turned off the scanner.
• All systems, sites, or search ranges that have a the startup key assigned to the one you
pressed will be unlocked.
• All systems, sites, or search ranges that have a different startup key assigned will be locked
out.
• The scanner will remember the last startup configuration you used when you power up the
scanner using just the power key.
Caution: If you press the wrong key when you press the power key to set your startup
configuration, and that wrong key doesn't have any systems assigned to that key, you will startup
your scanner with all systems locked out.
68
.
.
.

USING STARTUP KEYS

to save and exit.
to save and exit.