Uniden BCD96P2 Owner's Manual page 84

Note: Broadcast screen is not effective during some service searches.
1. Scroll to 'Broadcast Screen' and press E/
2. Scroll to 1 of 4 options and press E/
Set All Bands On - turns on broadcast screen on for all bands. Press MENU to return.
Set All Bands Off - turns off broadcast screen off for all bands.
Press MENU to return.
3.
Set Each Band - then scroll to each band and press E/
4. Press MENU to return.
Pager - the scanner skips known paging system frequencies.
FM - the scanner skips known FM frequencies.
UHF TV - the scanner skips known UHF TV frequencies.
VHF TV - the scanner skips known VHF TV frequencies.
NOAA WX - the scanner skips known NOAA weather frequencies.
Band 1-10 - the scanner skips known frequencies for custom broadcast ranges.
Program Band - Scroll to the custom band (1-10) and press E/
1. At 'Set Lower Limit' enter the lower limit of the frequency range and press E/
2. At 'Set Upper Limit' enter the upper limit of the frequency range and press E/
3. Scroll to the next band and repeat.
4. Press MENU twice to return.
Tone/Code Search selects whether the scanner searches for CTCSS/DCS tones, P25 NAC
codes, or no codes in Search and Close Call modes. The scanner ignores this setting in AM,
WFM, and FMB bands.
1. Scroll to 'Tone/Code Search' and press E/
2. Scroll to 1 of 3 options and press E/
Off - the scanner does not search and display any tones.
CTCSS/DCS Search - the scanner searches and displays only CTCSS/DCS tones.
P25 NAC Search - the scanner searches and displays only NAC tones.
Repeater Find this feature sets whether the scanner tries to tune to a repeater output frequency
when it detects a transmission on a repeater input frequency in Search and Close Call modes.
Since you can normally only hear one side of a conversation when you listen to an input frequency
transmission, turning this feature on can let you hear both sides of the conversation on the output
frequency. If the scanner detects the transmission on the output frequency, it beeps and 'Repeater
Found' appears, and it remains on the output frequency until transmissions end. The default
setting is Off.
1. Scroll to 'Repeater Find' and press E/
2. Scroll to On or Off and press E/
Max Auto Store this value sets how many hits the scanner will automatically store when it is in
either Search and Store or Close Call Auto Store mode. When the scanner reaches the maximum
number of hits you set, it stops the auto-store operation.
Scroll to 'Max Auto Store' and press E/
1.
2. Enter a value from 1-256 then press E/
80
.
.
.
.
.
to save and exit.
.
to save and exit.
to turn off or on.
.
.
.