Operating Procedures - Record Power TS315 Original Instruction Manual

5. Operating Procedures

5.1. Control Panel
The electric board consist of the following devices:
5.1.1 Control Functions
A - ON/OFF switch - connects and disconnects input power.
O - the machine is not powered;
I - the machine is powered.
B - Stop button.
When the button is pressed, the power is immediately cut. It is a mechanically-
operated push-button. Reset this button by turning it clockwise.
5.1.2 Machine Start
Push the green button (A, Fig.34) to position I.
5.1.3 Machine Stop
Press the (B, Fig.34) button.
Push the red button (O) (A, Fig.34), or emergency stop (B, Fig.34).
5.2. Working With the Table Saw
For cutting veneered wood, use of the scoring blade is indispensable to
prevent chipping. When the scoring blade is not needed, lower it completely
underneath the table. Adjust the scoring blade as described in section 4.
5.2.1 Cutting With The Sliding Beam
When machining large panels, position the telescopic ruler and the squaring
frame as per Fig. 35; with this position maximum cutting length is obtained.
1) The first cut - slide the sliding beam completely to the right;
Place the panel (C, Fig.35) against the aluminium ruler (E, Fig.35);
proceed with cutting, moving the sliding beam forward against the saw blade.
CAUTION: When loading the piece onto the sliding beam, take care not to
knock the saw blade.
2) Second Cut
Turn the panel by 90°, place the side previously trimmed against the guide (E,
Fig.36) and repeat the operations as in point 1.
B
Fig.34
Fig.35
Fig.36
A