Scoring Blade Installation And Adjustment - Record Power TS315 Original Instruction Manual

4.2 Scoring Blade Installation And Adjustment

To assemble the scoring blade:
Insert wrench (A, Fig.25) in the blade-holding flange hole.
Loosen lock nut (C, Fig.25) using a hex wrench (B, Fig.25) and remove flange
(D, Fig.25).
Assemble, by following this sequence, these parts: blade (E, Fig.25) with the
teeth opposed to the ones of the saw, flange D and nut C.
Tighten the nut using the wrench A & B
NOTICE
For cutting panels coated with finishing material you should use the scoring
blade (A, Fig.26) ; position the scoring blade so as to score 1-1,5 mm.(Fig.26)
Proceed as follows if it is necessary to adjust scoring blade positioning with
respect to the saw:
Loosen the fastening pin by introducing the hex wrench into hole (M, Fig.27);
Regulate the alignment of the scoring unit with the saw by turning the setting
eccentrically through hole (N, Fig.27);
Adjust the height of the scoring blade using L wrench through hole (P, Fig.28).
B
C
Fig.25
Fig.26
M
N
Fig.27
Fig.28
A
D
E
A
P
16 17