Squaring Frame Installation - Record Power TS315 Original Instruction Manual

3.4.3 Squaring Frame Installation (Optional)
Mount the squaring frame support bracket (A, Fig.10) onto the cabinet.
Insert the slider (B, Fig.10) into the swing arm and make sure the thrust
bearing is in place (C, Fig 10).
Insert the support (D, Fig. 11) in the groove of the sliding beam
(E, Fig.11).
Position the swinging support (B, Fig.12) as shown in the figure; rest the frame
(G, Fig.12) on the support bracket (H, Fig.12).
CAUTION
The screws on support bracket (H, Fig.12) must sit perfectly in the special hole
underneath the frame (G, Fig.12).
Level the table (G, Fig.12), if necessary, turning the nuts (I, Fig.12).
Tighten the knobs (F, Fig.12).
Insert the square nut with the presser in the groove of the sliding beam E and
lock it onto the beam. When the sliding beam E is
not used, lock it with the locking knob.
3.4.4 TELESCOPIC CROSS CUT FENCE INSTALLATION
Place the telescopic cross cut fence on the table (G, Fig.13), inserting the
fulcrum (K, Fig.13) in the hole.
Position the telescopic ruler in such a way that the pin (K, Fig.13) fits into
place against the gib (L, Fig.13). The gib L is adjusted by our technicians and is
used to rapidly position the telescopic ruler at the right distance from the saw
blade (only at a 90° position).
For use, position the ruler referring to the plate (J, Fig.13), move
the coaster (M, Fig.13) into place on the upright of the table
(G, Fig.13) and tighten the knobs (F, Fig.13). The ruler is fitted with an
extractable telescopic extension (N, Fig.13), which may be lengthened as
required after loosening the knob (O, Fig.13).
A
B
Fig.10
F
Fig.11
F
G
Fig.12
N
F
O
G
Fig.13
C
D
E
I
B
L
M
K
J
H