Installations Of Loose Parts - Record Power TS315 Original Instruction Manual

3.4. Installation of
Loose Parts
3.4.1 Blade Guard - Installation
CAUTION
The guard must always be used and must be positioned in such a way as to
completely cover the blade.
• Lift the saw assembly by means of the lever A after loosening
handle B.
• Fit protection C and tighten the handle E
A
B
3.4.2 FITTING THE SLIDING BEAM
CAUTION
The sliding beam extrusion is heavy. To avoid injury and possible damage to
the beam, please seek assistance from another person.
1. Familiarise yourself with the components of the sliding beam Fig.6
A. Plunger lock assembly
B. Operating knob
C. Fixings to secure sliding beam to brackets
D. Sliding beam
2. Attach the plunger lock assembly to the sliding beam by
inserting it through the locating hole in the side of the sliding
beam extrusion and secure with the nut provided (Fig 7).
3. Assemble the operating knob and thread the square nut onto
the start of the thread of the knob. Slide the square nut into
the corresponding recess on the side of the sliding beam
extrusion and locate towards the front of beam. Fully tighten
the knob by rotating in a clockwise direction (Fig 8).
4. Attach the sliding beam to the mounting brackets using the
fixings supplied (the mounting brackets are already fitted to the
saw body during the production process) (Fig 9).
E
C
A
B
C
Fig.6
Fig.7
Fig.8
Fig.9
D
10 11