Operating Procedures - Record Power TS250RS Instruction Manual

6. OPERATING
PROCEDURES
6.1 MACHINE START AND STOP
The switch's positon of the machine is as the picture
shown. Push green button to start; push red button to
stop.
6.2 WORKING STATION
WARNING
The machine has been designed to be used by one
operator only.
A - Working with the sliding table (squaring)
B - Parallel cut side
6.3 WORKING WITH THE MACHINE
The choice of the method to use to make a cut
with the circular saw depends on the dimensions of The
wood to be machined and the type of machining to be
carried out. For cutting ennobled wood, use of the
engraver is indispensable to prevent chipping.When the
engraver is not needed,lower it completely underneath
the table.
6.3.1 WORKING WITH THE SLIDING TABLE
- Put workpiece on the sliding table. Fix it with the
aluminium stoper B and plate pusher C.
- Stand on position A, push the sliding table forward to
across blade.
6.3.2 WORKING WITH RIP FENCE
- Lock the sliding table. Put the workpiece against the
side surface of rip fence. Push the workpiece forward
across blade.
- For your safety, please use the plastic pusher priority.
A
A
B
-14- -15-
Fig.6.1
B
Fig.6.2
C
A
Fig.6.3.1
Fig.6.3.2