Additional Safety Instructions For Table Saws - Record Power TS315 Original Instruction Manual

Additional Safety Instructions
For Table Saws
SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL TIMES WHEN THE TABLE
SAW IS BEING USED.
WARNING: FOR YOUR OWN SAFETY, DO NOT ATTEMPT TO
OPERATE YOUR TABLE SAW UNTIL IT IS COMPLETELY ASSEMBLED
AND INSTALLED ACCORDING TO THE INSTRUCTIONS.
SAFE OPERATION
1. The table saw should be bolted to the floor where possible.
2. If you are not thoroughly familiar with the operation of table saws,
obtain advice from your supervisor, instructor, or other qualified person or
contact your retailer for information on training courses. Do not use this
machine until adequate training has been undertaken.
3. Never turn the machine 'ON' before clearing the table of all objects
(tools, scrap pieces etc.)
4. Ensure that:
(i) the voltage of the machine corresponds to the mains voltage.
(ii) To use an earthed power source (wall socket).
(iii) The cord and plug are in good condition, i.e. not frayed or damaged.
(iv) No saw teeth are missing and the blade is not cracked or split.
Otherwise replace blade.
(v) The blade is aligned.
5. Never start the machine with the saw blade pressed against the
workpiece.
6. Never apply sideways pressure on the blade.
7. Care must be taken when cutting wood with knots, nails or cracks in it
and / or dirt on it.
8. Never leave the machine running unattended.
9. Do not use saw blades which are damaged or deformed.
10. Ensure the selection of the saw blade is suitable for the material to be
cut.
11. If the electrics are damaged, parts must only be replaced by a qualified
electrician.
12. Never use a long extension cable.
13. Always use a push stick and keep hands clear of the blade.
14. Never remove the crown guard or riving knife. These are there to
protect the user.
15. WARNING LABELS – It is important that labels bearing Health &
Safety Warnings are not removed or painted over. New labels are available
from Customer Services.
16. MECHANICAL SAFETY – The security of all clamps and work holding
devices should be checked before switching on.
17. WOOD DUST – The fine particles of dust produced in cutting
operations are a potential health risk. Some imported hardwoods do give
off highly irritant dust which causes a burning sensation. We strongly
recommend the use of a dust collector and dust mask/visor. Our Customer
Services Department will also be happy to advise you on the correct unit
for your needs.
18. This machine falls under the scope of the 'Health & Safety at Work etc.
Act 1974', and the 'Provision & Use of Work Equipment Regulations 1998'.
We recommend that you study and follow these regulations. For further
help on any of the above matters please contact our Customer Services
Department at :-
Tel: 01246 561 520 Fax: 01246 561 537
WARNING: Do not allow familiarity (gained from frequent use of your
machine) to cause complacency. Always remember that a careless fraction
of a second is sufficient to inflict severe injury.
4 5