Cutting With Rip Fence - Record Power TS315 Original Instruction Manual

3) Third Cut
Position the stop (F, Fig.37) according to the cutting width to be executed;
Turn the panel 90°
Place the trimmed side against the aluminium ruler (E, Fig.37) and against the
stop (F, Fig.37)
Proceed with cutting.
4) Fourth Cut
Repeat the operations as step 3.
CAUTION: Always secure the workpiece by means of the hold down when
a sliding beam is used. Always use supports when machining large panels.
Working against the fence, with the scorer on, should be carried out with the
utmost care because scorer rotation is executed at the same time as workpiece
feeding which causes it to be carried along.

5.2.2 Cutting With Rip Fence

To perform parallel cuts use fence (A, Fig.38). To position and adjust, follow the
instructions in section.4. Position the sliding beam as shown and lock it with the
knob (B, Fig.38). For positioning the workpiece against fence (A, Fig.38) refer to
scale (C, Fig.38).
CAUTION: The end of fence (A, Fig.39) must be positioned lengthwise along
an imaginary line (B) which starts half way down the blade and slips forward by
45°. This is to prevent the workpiece kicking back towards the operator. Never
put hands near the scoring blade and always use a push stick. The machine is
supplied with a push stick.
Fig.37
A
C
B
Fig.38
Fig.39
20 21