General Lubrication - Record Power TS315 Original Instruction Manual

6.1.2 Scoring Belt
Completely lower the saw assembly;
Push the belt tightener (E, Fig.44) to the left and taking off the belt (F, Fig.44);
Taking off the spring (A, Fig.44) from the tightener (E, Fig.44) and replace the
belt.
6.2. General Cleaning
After each working cycle, thoroughly clean the machine and all of its parts,
vacuum the shavings and dust and remove any resin residues. Use compressed
air only when strictly necessary, using protective glasses and a mask. In particu-
lar, clean the following parts:
1) the beam sliding rail (A, Fig. 44);
2) the sliding beam grooves (B, Fig.45);

6.3. General Lubrication

Weekly clean and lubricate all the mobile couplings of the machine with a thin
film of oil and grease. Protect all belts and pulleys to avoid contamination with
oil.
6.4. Replacement And Disposal
Should replacement become necessary, the machine parts must be replaced
with original components in order to guarantee their efficiency.
The replaced parts must be disposed of in compliance with the laws in force in
the country of use. Repairs should be carried out by an experienced and quali-
fied person to reduce the risk of damage to the machine and eliminate any risks
to the user.
E
A
Fig.44
B
Fig.45
F
A
22 23