Installation Zone Characteristics - Record Power TS250RS Instruction Manual

4.2

INSTALLATION ZONE CHARACTERISTICS

WARNING
It is prohibited to install the machine in explosive environments.
The installation zone must be selected evaluating the work space required depending on the dimension of the pieces
to be machined,and taking into account that a free space of at least 800 mm must be left around the machine.It is also
necessary to check The floor capacity and its surface, so that the machine base is evenly resting on its four supports.A
power outlet and a chip-suction system connection shall be closeto the selected machine setting and it must be
conveniently lighted (luminous intensity: 500 LUX).
4.3 INSTALL OF LOOSE PARTS - INTRODUCTION
A few elements will be disassembled from the machine main structure due to packaging and shipping requirements.
These loose parts should be installed as follows.
4.3.1 INSTALL CABINET STAND
Tools Required for Assembly:
- Wrench 10mm
- Wrench 13mm
WARNING
Please tighten all bolts and nuts absolutely. Otherwise,
may cause machine wobble or serious injury to the
operator or other persons.
- Install A, B, C, D with bolts, washers and nuts (1, 2, 3).
- Install 4, 5 to the stand support leg E, then install E to D
with 6 and 7.
- Insert the rubber feet to the bottom of panels.
- Fix G to the cabinet stand with 8.
4.3.2 INSTALL UPPER CABINET ASSEMBLY
Tools Required for Assembly:
- L wrench 5mm
- Phillips Screwdriver
WARNING
Please tighten all bolts and nuts absolutely. Otherwise,
may cause machine wobble or serious injury to the
operator or other persons.
- Install upper cabinet assembly A to cabinet stand D with
4sets of bolts and washer 2, 3.
- Fix the handwheel E with screw 4.
- Fix the handwheel F with screw 5.
- Disassemble the switch plate B, take out the switch
C, fix the switch to upper cabinet assembly A with 4pcs
screw 1. Reassemble the switch plate on position.
A
1
2
3
6 7
E
5
4
C
1
3
2
-10-
G
8
A
B
D
F
Fig.4.3.1
A
B
E
D
Fig.4.3.2
C
F
4
5