Table of Contents
Advertisement
Installation Procedures
Power Connectors
The 20-pin male block connector is connected to the ATX power supply. The
4-pin male block connector is for the ATX_12V power use. All two connectors
are linked with your ATX power supply. The plug from the power supply will
only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
System Chassis Open Alarm Connector
The 2-pin male connector allows you to enable (or disable) system activation
if and when the system out casing is being removed. A high level signal to the
connector will indicate to the system that the chassis has been opened.
2 - 11
Advertisement
Table of Contents
