Table of Contents
Advertisement
Installation Procedures
5). Connect Devices
Floppy Diskette Drive Connector
This connector provides the connection with your floppy disk drive.
Insert the floppy ribbon cable (below)
onto the floppy connector.
The colored stripe (indicated by the
arrow head, right) of the ribbon cable
must be the same side with the Pin 1.
IDE Device Connectors
The two connectors, PRIMARY and SEC-
ONDARY, are used for your IDE hard disk
drives, CD drives, LS-120|drives, or IDE
ZIP drives. The red stripe of the ribbon
cable must be the same side with the Pin
1. The two connectors, IDE3 and IDE4,
are optional. They are linked with your
RAID devices (level 0, 1, 0+1). IDE3 and
IDE4 support storage hard disks only.
Insert the floppy ribbon cable (below)
onto the floppy connector.
The colored stripe (indicated by the
arrow head, right) of the ribbon cable
must be the same side with the Pin 1.
2 - 9
Advertisement
Table of Contents
