Install Memory Modules - FIC P4-875P MAX User Manual

875 Dynasty Mainboard Manual

2). Install Memory Modules

1. Locate DDR DIMM sockets
on the mainboard.
2. Install DDR DIMM straight down
into the socket 1 using both hands,
then socket 2, and so forth.
3. The clip on both ends of the
socket will close up to hold the
DDR DIMM in place when the DDR
DIMM reaches the socket bottom.
NOTE:
1. To enable dual channel, it must be-
same density (128/256MB, etc.); same technology (128/256Mb, etc.);
same bus width (x8, x16); both single- (or dual-) sided; installed on
symmetical memory slots.
2. If your system uses an 800MHz CPU with DDR333 memory, the
memory interface of the chipset will run at 320MHz only. (Please
read Page 1-4, Memory for details.)
Press the clips with both hands to remove the DIMM.
2 - 4