Slewing Brackets - Permobil Street Service Manual

Slewing brackets

Removal
1. Raise the seat to its highest position. To raise
it manually, see page 28, 31.
2. Turn off the main power switch on the control
panel.
3. Put the circuit breaker in the "OFF" position;
see page 35.
4. Remove the bolt that secures the slewing
bracket; see figures 25 and 26.
Front slewing bracket
5. Remove the front shock absorber bracket;
see page 13.
For removal of wheel fork, front wheels and friction
brake, see the respective chapters.
Rear slewing bracket
6. Remove the lower shock absorber bracket;
see page 13.
7. Remove the tie rods; see page 16.
For removal of drive wheels, drive motor and
support wheels, see the respective chapters.
Fitting
Fitting is the reverse procedure.
Use a torque wrench to tighten the bolt to
48 ft-Ibs (65Nm).
3
2
1
3
Fig. 26. Removal/fitting of slewing brackets.
17
Fig. 25. Front and rear slewing
bracket attachment.
Pos. Description
1 Bolt, ISO 10642 M10x25 10.9 Fe/Zn 8
C1 / LOCKING COAT DIN 267-28
2 Washer,
3 Bushing, 35/39/48X13 PDE-F
Slewing brackets