Table 5-24 Auto Provision Parameters Setting - New Rock Technologies NRP1012 User Manual

NRP1012 Series IP Phone

Table 5-24 Auto provision parameters setting

Field name
Auto Update Setting
Current Config
Version
Common Config
Version
CPE Serial
Number
User
Password
Config Encrypt
Key
Common Config
Encrypt Key
Save
Autoprovision
Information
DHCP Option Setting
DHCP Option
Setting
Custom DHCP
Option
Plug and Play
Enable PnP
PnP Server
PnP Port
PnP Transport
PnP Interval
Phone Flash Settings
Server Address
Config File Name
Protocol Type
Update Interval
New Rock Technologies, Inc.
Explanation
Specifies the version of the current configuration file. If the version of the CFG
configuration file downloaded is the same as same as that of the running one, the
system does not enable auto provision. If the terminal confirms the configuration in
Digest mode, the terminal wouldn't upgrade configuration unless the configuration on
the server is different from the running configuration.
Specifies the version of the common configuration file. If the configuration
downloaded and the running configurations are the same, the auto provision would
stop. If the terminal confirms the configuration in Digest mode, the terminal wouldn't
upgrade configuration unless the configuration in the server is different from the
running configuration.
Specifies the CPE serial number.
Specifies the username of an FTP server If the download protocol is TFTP, this
parameter does not need to be configured. If the download protocol is FTP, and no
value is set to this parameter, the system uses the default value anonymous.
Specifies the password for logging in to the FTP server.
Inputs a password if the configuration file to be upgraded is encrypted.
Inputs a password if the common configuration file to be upgraded is encrypted.
Saves the username, password, authentication and ID information configured for
HTTP/HTTPS/FTP. Information saved on the phone remains unchanged unless the
URL information configured on the server changes.
Specifies the DHCP option. The value can be DHCP custom option, DHCP option 66,
or DHCP option 43. Select any of the preceding modes so that the application
parameters can be obtained automatically. By default, the DHCP option is disabled.
The value ranges from 128 to 254. The custom DHCP option must be identical with
the one defined in the DHCP server.
Enables the PnP function. If PnP is enabled, the terminal will send a SIP SUBSCRIBE
message to a multicast address when it starts up. Any SIP server supporting SIP
SUBSCRIBE messages will reply with a SIP NOTIFY message containing the Auto
Provisioning Server URL. The URL can be used to obtain the configuration files to be
downloaded to the terminal.
Specifies a PnP server.
Specifies a PnP port.
Specifies a PnP transfer protocol.
Specifies the PnP timeout period, in hours.
Sets FTP/TFTP/HTTP server IP address for auto update. The address can be an IP
address or Domain name with subdirectory.
Sets the name of the configuration file which needs to be updated. The system will use
the MAC address as the config file name if the config file name is null. For example,
000102030405.
Specifies the protocol type, which can be FTP, TFTP, HTTP or HTTPS.
Specifies the update interval, in hours.
User Manual
5-47