Feature - New Rock Technologies NRP1012 User Manual

User Manual
Table 5-18 Audio setting parameters
Name
First Codec
Second Codec
Third Codec
Fourth Codec
Fifth Codec
Sixth codec
Onhook Time
Tone Standard
Handset Volume
Default Ring
Type
Speakerphone
volume
Headset Ring
Volume
G729AB Payload
Length
G723.1 Bit Rate
G722 Timestamps
DTMF Payload
Type
Enable VAD
Enable MWI
Tone

5.6.2 Feature

In this Web page, you can configure parameters listed in Figure 5-20:
5-30
Description
Specifies the first preferential DSP codec. The value can be G.711A/u, G.722, G.723.1,
726-32 G.729AB, or None.
Specifies the second preferential DSP codec. The value can be G.711A/u, G.722,
G.723.1,726-32 G.729AB, or None.
Specifies the third preferential DSP codec. The value can be G.711A/u, G.722,
G.723.1, 726-32 G.729AB, or None.
Specifies the forth preferential DSP codec. The value can be G.711A/u, G.722,
G.723.1, 726-32 G.729AB, or None.
Specifies the fifth preferential DSP codec. The value can be G.711A/u, G.722,
G.723.1, 726-32 G.729AB, or None.
Specifies the sixth preferential DSP codec. The value can be G.711A/u, G.722,
G.723.1, 726-32 G.729AB, or None.
Specifies the minimum response time of Hand down. The default value is 200, in ms.
Sets the tone standard.
Sets the sound volume of the handset.
Sets a default ring tone.
Sets the sound volume of the speaker.
Sets the payload length of the G.729 voice codec.
Sets the G.723 bit rate. The value can be5.3 Kbit/s or 6.3 Kbit/s.
Sets the G.722 timestamp. The value can be 160/20 ms or 320/20 ms.
Set DTMF Payload Type.
Enables the v
oice activation detection (
length cannot exceed 20 ms.
VAD) function. If enabled, theG.729 payload
NRP1012 Series IP Phone
www.newrocktech.com